Nanoplasty Tyrrel Reductblond (Reductblond) is a new preparation for smoothing and reconstructing light curls and curls with damaged areas. Aligns strands on rows up to 7 months. Reductblond restorer contains amino acids, rice proteins, silk proteins, shea butter, avocado oil, keratin, honey. The active elements, working with the hair cuticle, change the amino acid chains and create a new hair shape. Reconstructs the lipid layer during the nanoplasty procedure. It has a slight tinting effect.

Why buy nanoplastic?
 

• High-quality curl alignment;
• There are no hazardous substances in the composition ;
• The result lasts up to 7 months;
• Provides a sufficient level of nutrition and hydration;
• Reconstructs the lipid layer inside the hair;
• Returns health, elasticity, radiance, beauty to strands;
• There is no smoke and smell during the nanoplastic procedure;
• No dangerous ingredients in the composition;
• Can be used for damaged curls.

Instructions:

< ol>

• Using a spray bottle, moisten the hair with water.
• Strands, starting from the occipital area, apply the composition to the hair, retreating from the roots 1-2 cm, distribute the product along the entire length. Use a brush and a fine-toothed comb to apply. Comb each strand 5-7 times until foam appears. (If there is too much foam, then you have applied a lot of composition. Just separate the next strand and, without applying a new portion of the product to it, comb it along with the strand, with excess composition). Apply the product to all hair.
• Leave the composition on the hair for 40-60 minutes (depending on the type of hair).
• Without using shampoo, rinse the hair under running water. Rinse off approximately 20% of the product. Do not rinse off completely!
• Blot your hair with a towel and dry with a hair dryer and hands, do not use brushes to dry. To dry your hair 100%, divide it into sections and dry it in sections.
• For additional moisture and protection, argan oil can be applied to dry hair before the straightening step.
• Divide hair into 3 sections ( one occipital and two temporal) and starting from the occiput, separating strands 1-1.5 cm thick, work through the hair with an iron with titanium or tourmaline plates. Each section should be pulled at least 15 times at a temperature of 210-230 degrees for healthy, coarse and dense hair and at 180-190 degrees for thin and severely damaged hair.
• Rinse hair with any shampoo WITHOUT sulfates and apply to 2 minutes any conditioner or hair mask. Rinse hair under running water, blow dry.

Tips:

  ;

• Skin tests are recommended before the procedure.
• Always align roots larger and tips smaller , thus preventing excessive drying from heat.
• Do a preliminary test on one strand. Wait at least 60 days for a full straightening. For the test strand - repeat.
• The tool can "eat" shade of hair, it is better to dye hair after 14 days of the procedure.
• After the procedure, it is recommended to use sulfate-free home care to maintain and prolong the effect.