Nanoplasty for hair Oxyreduct Turrel – a completely new drug for straightening curls. The unique composition, together with innovative technologies, helps to save the result of the alignment of the strands for 11 months! Active elements (honey, rice keratin, amino acids, panthenol) make hair stronger, softer, radiant and reconstruct damaged areas of hair.

Why buy nanoplasty?
 

• High-quality alignment of curls;
• No hazardous substances in the composition;
• The result lasts up to 11 months;
• Provides an adequate level of nutrition and hydration ;
• Reconstructs the lipid layer inside the hair;
• Restores health, elasticity, radiance, beauty to strands;
• There is no smoke and smell during the nanoplastic procedure;
• No dangerous ingredients in the composition;
• Can be used on damagedhair.

Instruction:

1. Moisten your hair with water using a spray bottle.
2. Strands, starting from the back of the head, apply the composition to the hair, retreating from the roots 1-2 cm, distribute the product along the entire length. Use a brush and a fine-toothed comb to apply. Comb each strand 5-7 times until foam appears. (If there is too much foam, then you have applied a lot of composition. Just separate the next strand and, without applying a new portion of the product to it, comb it along with the strand, with excess composition). Apply the product to all hair.
3. Leave the composition on the hair for 40-60 minutes (depending on the type of hair).
4. Without using shampoo, rinse the hair under running water. Rinse off approximately 20% of the product. Do not rinse off completely!
5. Blot your hair with a towel and dry with a hair dryer and hands, do not use brushes to dry. To dry your hair 100%, divide it into sections and dry it in sections.
6. For additional moisture and protection, argan oil can be applied to dry hair before the straightening step.
7. Divide hair into 3 sections ( one occipital and two temporal) and starting from the occiput, separating strands 1-1.5 cm thick, work through the hair with an iron with titanium or tourmaline plates. Each section should be pulled at least 15 times at a temperature of 210-230 degrees for healthy, coarse and dense hair and at 180-190 degrees for thin and severely damaged hair.
8. Rinse hair with any shampoo WITHOUT sulfates and apply to 2 minutes any conditioner or hair mask. Rinse hair under running water, blow dry.

Tips:

• Skin tests are recommended before the procedure.
• Always align roots larger and tips smaller , thus preventing excessive drying from heat.
• Do a preliminary test on one strand. Wait at least 60 days for a full straightening. For the test strand - repeat.
• The tool can "eat" shade of hair, it is better to dye hair after 14 days of the procedure.
• After the procedure, it is recommended to use sulfate-free home care to maintain and prolong the effect.